AC Installation & High-Efficiency System Replacement in Baldwin Park & the San Gabriel Valley
A new air conditioner is only as good as its sizing and installation. Oversized systems short-cycle and leave humidity behind; undersized systems run nonstop through August. We size every system from a room-by-room load calculation and install to manufacturer specs so your warranty and efficiency rating actually hold up.

It may be time to replace your AC if
- Your system is 12–15+ years old
- It still uses R-22 refrigerant (installed before about 2010)
- Repairs over the last two summers add up to a third of a new system
- Some rooms are always too hot no matter the thermostat setting
- Your summer Edison bill keeps climbing year after year
- The outdoor unit is loud enough to bother you or your neighbors
Our step-by-step process
- 1
In-home assessment & load calculation
We measure the home, check windows, insulation, orientation and duct condition, and run a Manual J–style load calculation to determine the right tonnage.
- 2
Good-Better-Best options
You'll see clearly priced options from single-stage to variable-speed inverter systems, with the estimated operating cost of each.
- 3
Installation
We set a new pad if needed, install the condenser, coil and line set, pressure-test with nitrogen, and pull a deep vacuum (500 microns or lower) before releasing refrigerant.
- 4
Commissioning
We verify charge, airflow and static pressure, program your thermostat, and register your manufacturer warranty.
Efficiency & comfort benefits
Right-sized comfort
Even temperatures and better humidity control from a system matched to your home.
Lower operating cost
Moving from an old 10 SEER unit to a modern 16+ SEER2 system can cut cooling energy use substantially.
Quiet, modern refrigerants
Today's equipment is quieter and uses current-generation refrigerants.



AC Installation FAQs
What size AC do I need for my San Gabriel Valley home?
Many SGV homes land between 1 ton per 450 and 600 sq ft depending on sun exposure, insulation and ceiling height — but the only reliable answer is a load calculation. Try our BTU calculator for a starting estimate, then we'll confirm on-site.
What does SEER2 mean?
SEER2 is the current federal efficiency rating, measured under test conditions that better reflect real ductwork. Higher SEER2 means less electricity for the same cooling. In California (part of the DOE Southwest region), the minimum for most new residential split AC systems is 14.3 SEER2.
Do I need a permit to replace my AC?
Yes. California requires a permit for HVAC equipment replacement, and many installs require duct leakage testing. Ask about the permit requirements for your project when we write your estimate.
How long does an AC installation take?
A straightforward replacement is usually one day. Adding new ductwork or converting from a wall unit can take two to three days.
AC Installation near you
- AC Installation in Baldwin Park
- AC Installation in El Monte
- AC Installation in West Covina
- AC Installation in Covina
- AC Installation in Arcadia
- AC Installation in Monrovia
- AC Installation in Duarte
- AC Installation in Azusa
- AC Installation in Glendora
- AC Installation in La Puente
- AC Installation in Hacienda Heights
- AC Installation in Temple City
- AC Installation in Rosemead
- AC Installation in Alhambra
- AC Installation in Pasadena